Introducing the DNP Cameras in Motion Slider Motor Assembly And Pulley Assembly LT Edition. This is the same Motor And Pulley Assemblies used in our of the 48″ DNP Linear Motion Motorized Camera Slider designed for time-lapse photography which also may be used for cinematic applications. This product adds smooth motion to your time-lapse and video projects.
Looking to build your own slider then you come to the right place. This Motor And Pulley Assemblies works on the 8020 Inc. extruded aluminum series 10 1010 Rail. You can purchase this rail on eBay in lengths of 24″, 36″ 48″, 72″ and 96″.
This is our light duty size Slider Motor And Pulley Assemblies designed for the Micro 4/3 mirrorless cameras, Go Pro Cameras, Point-and-Shoot cameras and small-size video cameras. This version will work with smaller DSLR’s with a normal or wide-angle lens. Load capacity of 5 pounds including camera lens and tripod ball-head. These Motor And Pulley Assemblies were designed for photography but may be used for any of your DIY projects.
The Motor Assembly will work with most motors with the diameter of 37mm and a 6mm driveshaft. Motor is not included but can be purchased separately from us or are readily available on eBay. This motor mount will bolt directly to the end of the 8020 Inc. 1010 rail. All hardware is included to connect to the rail and no drilling required.
The Pulley Assembly is designed to work with a 5 pitch 3/8″ wide timing belt. A 10 tooth Pulley is included with this pulley assembly. This Pulley Assembly will bolt directly to the end of the 8020 Inc. 1010 rail. All hardware is included to connect to the rail and no drilling required with (hammer in anchors with #6 screw.)
I also include two 1/4-20 stainless Screws (As shown in pictures) if you prefer to tap the ends of the rails. Which will require a 1/4″ drill To drill out the #6 Screw hole on the motor assembly and pulley assembly and a 1/4 Thread tap To thread the ends of the 8020 Inc. series 10 1010 rail.
The Motor And Pulley Assembly are hand-built and tested before shipment. ( 8020 inc. rail is not included)
1 Motor Assembly with mounting hardware
1 Pulley Assembly with Pulley and mounting hardware
1 5 pitch x 3/8″ 10 tooth 6mm bore XL Pulley for motor.
1 7 peace Allen wrench set
Please Contact Us with your specifications and application needs and I will set up the components you needs.